Your Universal Remote Control Center
RemoteCentral.com
RS-232 & IP Control Forum - View Post
Previous section Next section Up level
Up level
The following page was printed from RemoteCentral.com:

Login:
Pass:
 
 

Topic:
Aquos Net RS-232 Commands on Sharp
This thread has no replies.
Post 1 made on Wednesday December 30, 2009 at 12:42
ALK3997
Long Time Member
Joined:
Posts:
November 2009
100
Now that I finally have both Sharp 40" panels properly responding to RS-232 commands from the MSC-400 (hint - certain AquosLink combinations in the main menu cause RS-232 errors in the E77 series), I'm trying to find an RS-232 command to enable Aquos Net on the LC-40LE700UN.

I suspect there isn't a command, but don't have proof either way. There is no mention of the Aquos Net in the manual's RS-232 command list. Has anyone found a command for the built-in Internet browser on these new Sharps?

If not I'll just program a separate IR-based separate device for the network access and control. A little kludgie but it will work.

Andy
Andy

Jump to


Protected Feature Before you can reply to a message...
You must first register for a Remote Central user account - it's fast and free! Or, if you already have an account, please login now.

Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our Marketplace. For information on how to advertise your service or product click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.

Hosting Services by ipHouse