Post 1 made on Saturday December 26, 2009 at 23:59 |
OOTAT28 Long Time Member |
Joined: Posts: | December 2009 15 |
|
|
Ok, so I have two video storm CMX1616V's and I am controlling it with a RTI RK2. I have 32 sets and 12 sources everything is programmed and functions properly but......I am new to RTI and cannot figure out how to get the two matrix switchers to function as one if that is what I am even supposed to do? It is connected via rs232. Am I missing somthing ? Any advice would be great! thnx
|
|
Post 2 made on Monday December 28, 2009 at 19:45 |
FASTLs Long Time Member |
Joined: Posts: | October 2004 480 |
|
|
Need a little more information. What processor are you using?
FASTLS
|
|
Post 3 made on Friday January 1, 2010 at 01:36 |
anyhomeneeds Super Member |
Joined: Posts: | December 2007 4,149 |
|
|
Yes, you are going to want to use 232 to get it to work the best.
|
"You can't fix stupid." |
|
Post 4 made on Thursday January 7, 2010 at 01:43 |
HiFidel Long Time Member |
Joined: Posts: | July 2005 165 |
|
|
Can you switch any of the outputs at all?
If the issue is you can control the first 16 outputs but not 17-32 because you can't find a code in the 232 database, have a look at the codes in the 232 database ("CMX Series Advanced Mode")
Here's the command for output 9 to component input 14: V0914\r the 09 and 14 would presumably be for the output and input, so try copying the commands, renaming them and replacing the numbers in the string as appropriate.
|
|
OP | Post 5 made on Sunday January 10, 2010 at 02:15 |
OOTAT28 Long Time Member |
Joined: Posts: | December 2009 15 |
|
|
thanks, got it done..just had to put a /F then string command and at the end..allows it to pass thru first switch.Now I am on to my next hang up. I am re-programming a xantech splcd64v and cannot get any rs232 commands to control this video storm cmx matrix! I have tried everything!
|
|
OP | Post 6 made on Sunday January 10, 2010 at 07:46 |
OOTAT28 Long Time Member |
Joined: Posts: | December 2009 15 |
|
|
I have checked my string commands thru Hyper-term and it works fine! when testing command thru xantech display flashes on matrix but thats about it. I have to do this job at night soooo there is no tech support to call during these hours.....Any ideas?
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.