| Post 1 made on Tuesday September 22, 2009 at 20:16 |
Hi,
Is there a class or webinar where I can learn about RS232 codes and programming? I already know about IR programming but wanted to be able to take it to another level in programming.
Thanks for your reply,
Henry
|
|
| Post 2 made on Wednesday September 23, 2009 at 16:46 |
joe sexton Founding Member |
Joined:
Posts: | March 2002
206 |
|
|
trial and error and reading the protocol documents. Serial is a dying interface as far as tech goes so I dont think you'll find a class at school for it. It's pretty simple really, There are 2 aspects of it that you need to know, the hardware side(pinouts of your connectors) and the software side which is the protocol. This info is in the protocol document of whatever equipment you are trying to control. If you read it and play with it then it will begin to make sense. Try hyperterminal on your pc to quickly check your strings.
|
Hey, thats a nice plasma, you can put that in the back of my truck... |
|
| OP | Post 3 made on Thursday December 3, 2009 at 14:58 |
Thanks Joe for your help.
Henry
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
