| Post 1 made on Monday October 26, 2009 at 22:33 |
loweball New Member |
Joined:
Posts: | August 2009
3 |
|
|
Hi,
I need some very basic help please with setting up a URC MX-810 to work with the URC dimmer switches by Lutron. I have installed the switched and updated the MX-810 but now I can't sync the two together. There's (purposefully?) no instructions on how to do this and I've not done it before. My first confusion was exactly what code to install on the MX-810, under URC by Lutron there were a ton of options (ID:410, ID:402 etc) and I didn't know which to pick so chose ID:401. Any specific instructions would be greatly appreciated. Thanks!
|
|
| Post 2 made on Saturday October 31, 2009 at 11:12 |
loweball New Member |
Joined:
Posts: | August 2009
3 |
|
|
|
Never mind, I worked it out. Just a matter of holding the dimmer switch for 8 seconds and the power on button on the remote to link them. Easy enough if you just know you have to do it!
|
|
| Post 3 made on Friday November 6, 2009 at 10:40 |
JoeFlabitz Regular Member |
Joined:
Posts: | December 2008
387 |
|
|
|
Now, if you want to change the scene (brightness), set the dimmer to the level you want, then press and hold the corresponding scene on the remote for 8 seconds.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
