| Post 1 made on Thursday July 23, 2009 at 17:16 |
Gene5301 Long Time Member |
Joined:
Posts: | April 2007
34 |
|
|
I am currently having trouble with my X-10 fan control setup. I am using (2) X-10 switches, both Leviton, to control the ceiling fan...the first is a 15A relay switch to turn the fan ON and OFF...the second is a dimmer switch to control the light. Both fan and light turn ON OK, but when I go to turn the fan OFF, the relay switch clicks twice...turning the fan OFF then ON again. This happens with both the MX-850 and the IR543 Command Center.
|
|
| Post 2 made on Friday July 24, 2009 at 13:47 |
raiders_fan94 Long Time Member |
Joined:
Posts: | September 2002
324 |
|
|
You probably have noise on the line and most likely caused by the fan motor itself. You should get a filter for the line.
|
Never underestimate the predictability of stupidity |
|
| Post 3 made on Thursday December 3, 2009 at 11:53 |
extenonline Lurking Member |
Joined:
Posts: | December 2009
9 |
|
|
Sounds like it may be a double IR signal that is being sent to the IR543, or maybe a IR toggle code. I think its too predictable for a noise problem. When you hit the fan OFF button, does the red LED on the ir543 blink twice?
|
Kelly R. Foster President & C.E.O. www.ExTenOnline.com |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
