| Post 1 made on Monday April 13, 2009 at 11:37 |
I suspect new equipment is available since the most recent thread I found on this subject so ...
I need to couple and amplify X-10 signals in my home which has the following characteristics.
- 4500 Sq ft.
- 400 amp service (Two 200 AMP panels)
- Whole house surge suppressor in each panel
What coupler/amplifier is the best for my situation? Do I need one in each panel? (The panels are both fed from the same meter base as is typical.)
Thanks for any help.
|
|
| Post 2 made on Thursday April 30, 2009 at 23:20 |
Jim Fouch in Southern California Founding Member |
Joined:
Posts: | August 2001
117 |
|
|
The ACT CR 230 coupler/repeater is generally well regarded and I have had one installed for about ten years.
I would think you would need one in each panel, but for better information you might try the forums at:
[Link: cocoontech.com]
They are to Home Automation what this site is for Remotes.
|
Cheers, Jim. |
|
| Post 3 made on Friday September 11, 2009 at 11:50 |
Msradell New Member |
Joined:
Posts: | September 2009
1 |
|
|
JV Digital Engineering makes a unit that if the most powerful amplifier/repeater I've seen. It's called the XTB-IIR. Not only is it an amplifier and a repeater but it also has a jack so it can directly replace your PSC05 or whatever other input interface you use. You can buy it either as a kit or fully assembled.
Here's a link to their website: jvde.us/
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
