Post 1 made on Sunday October 26, 2003 at 09:55 |
planenut Long Time Member |
Joined: Posts: | August 2003 32 |
|
|
Once I enter programming mode on the lamplinc (O16, N16, M16, P16, M16) can I enter more than one lamplinc address for example B2 set dim level then b3 set dim level b4 set dim level and then exit with (M16, N16, O16, P16) followed by the scene address?
Tryin to save a few steps and clicks on the maxi controller...
|
|
Post 2 made on Sunday October 26, 2003 at 12:15 |
Deane Johnson Founding Member |
Joined: Posts: | August 2001 263 |
|
|
I don't think so. What you would be doing is sending it additional signals before locking what you wanted in. There is no way the modules could determine which set of instructions was for it specifically.
I ended up replacing my Lamplincs with PCS (at ridiculous cost). Lamplincs are prone to loosing their programming during power outages or surges. Once I got a bunch of scenes programmed in, it was a royal pain to go back and redo them each time.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.