Post 1 made on Sunday October 26, 2003 at 09:09 |
planenut Long Time Member |
Joined: Posts: | August 2003 32 |
|
|
Is there a code I can send to dim the lights to a specific level or do I have to use the dim command and then press the set button? I have read the instructions that came with both.
I have several lamplinc's and pcs switches, and ir543, a maxi controller and a pronto 3000.
|
|
Post 2 made on Sunday October 26, 2003 at 12:19 |
Deane Johnson Founding Member |
Joined: Posts: | August 2001 263 |
|
|
You have to use the dim command and the set button. Not very precise, but that's the way they're made. The dim ramp rate is even harder to set.
After programming the PCS switches with a computer, the Lamplincs are a little frustrating if you're setting a bunch of scenes up and want reasonable precision.
The good thing is that Lamplincs provide a lot of value and features for their low cost. The PCS lamp dimmers are ridiculously expensive.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.