Post 1 made on Thursday July 5, 2001 at 16:11 |
Willam Historic Forum Post |
|
|
Hi all.
Been running some X-10 lighting for awhile. I have two transmitters, but both sets run on "A".. (so I can run them with my Pronto).
Anyway, in the last three days, light #1 on one set has been just popping on randomly in the evenings. Can't figure out why.
These are the bedroom lights, and there are three in the room, but only the one plugged into the transmitter is doing this.
I changed those lights to "B"... and so far so good.
But anyone understand what happened, and why?
|
|
OP | Post 2 made on Thursday July 5, 2001 at 17:17 |
www.RRDeals.com Historic Forum Post |
|
|
Absolutely - (and this is why changing the housecode fixed it) Your neighbor has X10!
I think it's good advice to say this: NEVER use housecode A!
|
|
OP | Post 3 made on Friday July 6, 2001 at 11:00 |
Tony Yau Historic Forum Post |
|
|
Someone also said never use housecode M. Apparently it's got problems.
|
|
OP | Post 4 made on Friday July 6, 2001 at 12:06 |
Uncle Sergi Historic Forum Post |
|
|
1. If You remove house code wheel, You'll get M house code 2. If You use TM751, You'll get M-Dim command almost every time You send "any_letter-Dim" command. 3. I don't like M
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.