Post 1 made on Saturday June 23, 2001 at 01:12 |
mason hatcher Historic Forum Post |
|
|
OK,
I know from the dryer test that I need a Phase Coupler in my house.
I am using activehome software and set up my geographic location and set my driveway floodlights (using a wall switch) and front porch light (using the screw in switch) on a "dusk to dawn" timer. I have set the check box to send the program to the interface.
When I open activehome on the PC during the hours that the lights should be on, should the modules on the PC show the switch in the on position?
I am also getting intermittent operation of some modules, but I think the coupler will solve that.
Thanks again.
|
|
OP | Post 2 made on Saturday June 23, 2001 at 11:39 |
I think that the ActiveHome software, when you open it, just re-loads the last update of your set-up that you saved, and displays it the way you saved it each time. I'll have to run a check to see if this is true.
|
|
OP | Post 3 made on Saturday June 23, 2001 at 16:49 |
mason hatcher Historic Forum Post |
|
|
makes sense, since the timers are actually sent from the interface.
Thanks
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.