| Post 1 made on Tuesday March 27, 2001 at 08:58 |
Does anyone know if my Powermid ST539 will double in use as an IR543. I'm currently using it to control an IR unit located in another room but would love to use it with my x-10 control and my new Sony RMAV2100.
Thanks... Paul
|
|
| OP | Post 2 made on Tuesday March 27, 2001 at 12:52 |
Chris Lefebvre Historic Forum Post |
|
|
NO.
You MUST use the IR543. I have the exact same setup as you including the Sony 2100.
The powermid works as follows:
The "Powermid sender" receives an IR signal. It resends the signal as an RF signal. The "Powermid receiver" receives the RF signal and resends it as an IR signal.
The IR543 works as follows:
It receives an IR signal. It sends it over the house wiring using the X-10 control protocol to the appropriate module or modules.
-CL
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
