Post 1 made on Monday October 10, 2005 at 21:10 |
esikola Long Time Member |
Joined: Posts: | September 2005 20 |
|
|
Has anyone experienced double commands from an HD TIVO on the T3? The IR commands I am using came prepackaged in the TheatreTouch software. For instance if you hit channel, it goes up two. Guide, it goes on and off, etc. Please advise
Eric
This message was edited by esikola on 10/10/05 22:46 ET.
|
|
Post 2 made on Monday October 10, 2005 at 23:26 |
RTI Installer Super Member |
Joined: Posts: | March 2002 3,320 |
|
|
You need to reduce the number of repeats to 1 for each command, right click on the command select edit properties>infrared then change the number of repeats till you get the desired effect.
|
Never Ignore the Obvious -- H. David Gray |
|
OP | Post 3 made on Tuesday October 11, 2005 at 09:45 |
esikola Long Time Member |
Joined: Posts: | September 2005 20 |
|
|
It was set at one already. I will try to set it to zero and see what happens.
Thanks, Eric
|
|
Post 4 made on Tuesday October 11, 2005 at 22:32 |
roddymcg Loyal Member |
Joined: Posts: | September 2003 6,796 |
|
|
Any luck?? I have this problem on a job i need to go back and finish here soon.
|
When good enough is not good enough. |
|
Post 5 made on Saturday October 15, 2005 at 03:49 |
AVStoney Long Time Member |
Joined: Posts: | August 2003 60 |
|
|
i THINK THE ZERO REPEATS SHOULD WORK.
|
|
OP | Post 6 made on Sunday October 16, 2005 at 23:27 |
esikola Long Time Member |
Joined: Posts: | September 2005 20 |
|
|
Yep. It worked. It was wierd that the Tivo setting in Theatretouch were for 1 repeat.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.