Post 1 made on Saturday July 15, 2000 at 09:58 |
Hi All,
I would like to set some of the hard buttons so that they repeat when held down for longer than .3 seconds. The particular buttons are the cursor control buttons. This will allow me to move through a list without requiring a button press for each entry in the list. So, I created a macro using the "if else" for held down button. I set the command so that it repeated. Unfortunately, this did not work when used on ReplayTV.
Any ideas?
Thanks,
rick
|
|
OP | Post 2 made on Saturday July 15, 2000 at 10:22 |
Try using the sustain feature. If you right-click on the button and select Edit Button Properties and go to the Infrared tab you will see a check box to turn the sustain on and off. This sends out the command as long as the button is pressed.
Rob
|
|
OP | Post 3 made on Saturday July 15, 2000 at 16:09 |
Hi Rob,
Thanks for the response!
Just checked in the editor and the sustain feature is on by default.
Rick
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.