Post 1 made on Wednesday June 22, 2005 at 10:20 |
radiorhea Super Member |
Joined: Posts: | May 2002 3,264 |
|
|
Have you guys used the flags for a non discreet toggle cmmand. How do you do it? Thanks, RadioRhea
|
Drinking upstream from the herd since 1960 |
|
Post 2 made on Wednesday June 22, 2005 at 22:25 |
Digital Home Long Time Member |
Joined: Posts: | April 2005 147 |
|
|
Select test flag. Drag it to the macro you are using the toggle command in or series of commands. Insert the command or series of commands between the bracketed area just after else. This is for the on or to perform the function/s in a macro. It will only do this once . For off or to clear the previous comand or series under the off or relevent macro, drag the test flag over to the macro insert the command or series of commands before the brackets above the else. Just below the last command inserted select clear flag and drag it below the last command you have inserted between test flag and else but before the else.
Note. Both flags for must consist of the same number. I.E test flag 1 for on and also test flag 1 for off.
|
Still a CI at heart! |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.