| Post 1 made on Monday March 28, 2005 at 14:51 |
Rob Grabon Founding Member |
Joined:
Posts: | November 2001
1,392 |
|
|
Any one know why you can't do a page link as part of a RF macro?
I didn't realize it could be done at all until reading another post which explains that it can be done if the button is set for standalone.
Thanks,
Rob
This message was edited by Rob Grabon on 04/19/05 11:51 ET.
|
Technology is cheap, Time is expensive. |
|
| Post 2 made on Monday March 28, 2005 at 22:55 |
augsys Long Time Member |
Joined:
Posts: | January 2005
442 |
|
|
Because the RF macro runs on the RP6 not the remote.
|
|
|
| Post 3 made on Tuesday March 29, 2005 at 02:13 |
RTI Installer Super Member |
Joined:
Posts: | March 2002
3,320 |
|
|
Yes the macro runs on the RP6 but this should not prevent RTI from modifying the software to allow the switch within the macro, since the T2+ can perform both standalone or RF there really is no reason that an function overlap patch could not be written. This is really a needed fix. I have run into several instances where I could have used this function.
|
Never Ignore the Obvious -- H. David Gray |
|
| OP | Post 4 made on Tuesday April 19, 2005 at 11:54 |
Rob Grabon Founding Member |
Joined:
Posts: | November 2001
1,392 |
|
|
This is easier than I expected.
1. Create a system macro with the RF commands
2. Set the button properties to stand alone
3. Create a macro in the standalone button to first execute the system macro then do a page link
Wa-Hoo.
|
Technology is cheap, Time is expensive. |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
