| Post 1 made on Monday February 7, 2005 at 21:25 |
tjg Founding Member |
Joined:
Posts: | January 2002
5 |
|
|
Has anyone fed the RP-6 output directly to an "IR remote control" input to control a piece of equipment. I guess you could use a standard IR emitter from the RP-6 and plug an IR external receiver into the equipment and match up the emitter and receiver. But, have you ever just run a two conductor cable from the RP-6 to the IR input?
|
|
| Post 2 made on Tuesday February 8, 2005 at 03:49 |
RTI Installer Super Member |
Joined:
Posts: | March 2002
3,320 |
|
|
Yes! Successfully without any problems
|
Never Ignore the Obvious -- H. David Gray |
|
| Post 3 made on Sunday February 27, 2005 at 00:51 |
Glackowitz RC Moderator |
Joined:
Posts: | May 2002
3,793 |
|
|
I just did several components in several systems this week with Mono mini to mono mini jacks and had no trouble on any of them. They were Integra components,
as well as fed the high out into a Xantech connecting block with just a 2 conductor wire.
Glack
This message was edited by Glackowitz on 03/04/05 15:41 ET.
|
There's no worse feeling than that millisecond you're sure you are going to die after leaning your chair back a little too far. |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
