Post 1 made on Thursday October 21, 2004 at 13:50 |
tonystugats Lurking Member |
Joined: Posts: | December 2002 8 |
|
|
Is there anyway possible to share RF commands as well as IR commands on a T2+ while sending a macro?
|
|
Post 2 made on Friday October 22, 2004 at 14:49 |
markrubin Founding Member |
Joined: Posts: | February 2002 919 |
|
|
yes you can do that:
-set up a macro for your RF commands -on the same button, add an IR command: be sure to set it's properties
This message was edited by markrubin on 10/22/04 15:30 ET.
|
|
OP | Post 3 made on Wednesday October 27, 2004 at 08:07 |
tonystugats Lurking Member |
Joined: Posts: | December 2002 8 |
|
|
Thanks Mark, I'll give it a go.
|
|
Post 4 made on Wednesday October 27, 2004 at 11:52 |
markrubin Founding Member |
Joined: Posts: | February 2002 919 |
|
|
It was not clear from your post if the IR command was to be sent through the RF module or direct from the T2+: if direct, set the properties of the IR command to "stand alone IR" by right clicking on the command to bring up the properties menu
also, you can set the macro to be executed only in the RF module: this may be work better (I have not tried this yet)
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.