| Post 1 made on Monday August 30, 2004 at 13:01 |
MoneyPenny Lurking Member |
Joined:
Posts: | August 2004
5 |
|
|
Hi, Would anyone out there have the codes for an Adcom GDD-1 Digital Dolby Unit? This is for the orignal T-2 Thanks, Dan
|
|
| Post 2 made on Tuesday August 31, 2004 at 18:12 |
vwpower44 Super Member |
Joined:
Posts: | August 2004
3,662 |
|
|
In the theatertouch software you can enter in the hex or .ccf IR codes. Try this [Link: remotecentral.com]If this does not work let me know. Mike
|
Stay Hungry, Stay Foolish... |
|
| OP | Post 3 made on Tuesday August 31, 2004 at 20:54 |
MoneyPenny Lurking Member |
Joined:
Posts: | August 2004
5 |
|
|
Mike,
Thanks for the response. I'm just not sure how to convert the .ccf codes into the theater touch .cml codes. I can't seem to open or read them from the software. I tried learning the remote but finding after 3 perfect learning sessions that the T-2 still doesn't duplicate the commands reliably. If you have any advice how to convert these codes I would appreciate it.
Dan
Other than that I think the T2 is a fantastic remote. And the software is unbelievably intuitive.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
