Post 1 made on Monday April 5, 2004 at 08:55 |
markrubin Founding Member |
Joined: Posts: | February 2002 919 |
|
|
I want to use the Button Test feature in a macro but cannot get it to work properly
I want to set up the macro so the command will not be executed unless I hold the button or double click it: so I add a button test command before the command to switch an input to a Lex processor: but the macro still executes
The only thing I have not tried is to put the command first and then the button test command but I thought I would ask the experts?
Thanks for any help
|
|
Post 2 made on Monday April 5, 2004 at 12:48 |
Impaqt RC Moderator |
Joined: Posts: | October 2002 6,229 |
|
|
All the commands need to be Within the "Test Button" symbol. Its an IF/Else statement. Take your macro and drag your commands INTO the Test button symbol. There are 2 slots for comand
IF the button is helf or x seconds
Command 1 Command 2 Command 3 etc etc ------------------------------------------- Else Page Flip (or whatever you want it to do if its just tapped)
|
|
|
OP | Post 3 made on Monday April 5, 2004 at 13:26 |
markrubin Founding Member |
Joined: Posts: | February 2002 919 |
|
|
Thank you: I missed the step of dragging it into the test button symbol: that should do it
Many Thanks
Mark
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.