Post 1 made on Tuesday November 11, 2003 at 23:04 |
myattjwil Lurking Member |
Joined: Posts: | November 2003 1 |
|
|
I'm trying to setup a T2 with an IRF-6 and a Philips TV. I am looking to solve a problem of knowing when the Philips is on a particular AV Input ie AV2, AV3, AV4 etc. I am not sure if the Video Sync modules will do the job or not. If anyone has some input, ideas, tips, or the exact design please let me know.
Thanks
Matthew
|
|
Post 2 made on Friday November 14, 2003 at 11:45 |
Warren Long Time Member |
Joined: Posts: | November 2002 264 |
|
|
The Video Sync modules are used to let the IRF 6 know if the device is on or off when you are forced to use toggle power commands. It cannot determine which input a TV is on.
I haven't seen any discrete input selection commands for Philips TV's but maybe someone else in here has.
If you can't find them, there may be one work around for your problem.
Many TV sets will automatically revert back to their tuner if you enter a channel number or hit channel up or down. If yours does, that will give you a known state to start from. You can build a macro that starts with Channel up.... then issue the number of input commands needed to reach the desire input.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.