Your Universal Remote Control Center
RTI Control Systems Forum - View Post
Previous section Next section Up level
Up level
The following page was printed from


Integration Designer to APEX
This thread has no replies.
Post 1 made on Friday May 29, 2020 at 13:17
Junior Member
March 2020
Having a heck of a time recreating my Integration Designer project to an APEX project.

I use RTI remotes and control processor to process the commands and then use a different automation system to receive the commands and process them.

My set up:

T1-B+ --> RM-433 --> XP-6 --> CM-232 --> Automation System

The T1-B+ remote buttons are programmed to send out custom RS-232 commands for each button. For example:

I set up my automation system and "learned" each button command. So, when the automation system receives "/FamilyRoom/Entertainment/Mode/DTV\r\n" it takes actions.

I cannot, for the life of me, figure out how to output the RS-232 in the same manner in APEX.

Jump to

Protected Feature Before you can reply to a message...
You must first register for a Remote Central user account - it's fast and free! Or, if you already have an account, please login now.

Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our Marketplace. For information on how to advertise your service or product click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.

Hosting Services by ipHouse