Does anyone know what the actual behavior of the 433 transmission? It seems not to sustain but rather rapid repeat. I also notice that only a few settings can be applied and most end up disabling the 433 transmission. Here are my observations...

1. If sustain is unchecked, it wont work.
2. If 433 code is placed direct on the button, no logic can be added to the button.
3. You can use the codes within macros and with certain logic operations but not all.

I can't figure out how the number of repeats affects the transmission or if the delay .3 seconds after code option actually does anything.

I would love to anyones experience, observations or k knowledge on the subject.

I've never noticed any weird stuff going on when I have used the Crestron trigger codes but then again I keep it pretty simple, button setup to do a progress bar page flip (8 pages) with the trigger code on it.
I set the button to stand alone mode with the trigger code on it and then in the macro do the page flips etc.

I do recall reading something about the amount of sustains being set to 4 or similar that makes them more reliable.