|Post 1 made on Wednesday February 14, 2018 at 04:31|
I am trying to control a 6x6 HDMI matrix switch via a ESC-2 and XP6
when i send the command to switch output 1 to input 1 it works once and then wont work again.
i press the button to send the command several times and sometimes it switches.
i have powered it off and on between each use with no change in result
i have changed the timing between transmission of characters without any change.
the command is 01 81 81 81 does any one have any ideas.
I have also tried IR commands, when i use the kramer IR remote it switches as it should but i cant get the XP6 to act on the ir commands being sent unless it use the standalone mode.
|OP | Post 2 made on Wednesday February 14, 2018 at 21:14|
got the rs232 working via virtual panel.
just need to get it working on the Tx4 remote now
|OP | Post 3 made on Friday September 7, 2018 at 21:42 |
got it working now.
those serial codes are tricky :)
Please read the following:
Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our Marketplace
. For information on how to advertise your service or product click here
. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.