Your Universal Remote Control Center
RTI Control Systems Forum - View Post
Previous section Next section Up level
Up level
The following page was printed from


serial control of kramer matrix switcher
This thread has 1 response. Displaying all posts.
Post 1 made on Wednesday February 14, 2018 at 04:31
Long Time Member
August 2013
I am trying to control a 6x6 HDMI matrix switch via a ESC-2 and XP6
when i send the command to switch output 1 to input 1 it works once and then wont work again.
i press the button to send the command several times and sometimes it switches.
i have powered it off and on between each use with no change in result
i have changed the timing between transmission of characters without any change.
the command is 01 81 81 81 does any one have any ideas.

I have also tried IR commands, when i use the kramer IR remote it switches as it should but i cant get the XP6 to act on the ir commands being sent unless it use the standalone mode.

OP | Post 2 made on Wednesday February 14, 2018 at 21:14
Long Time Member
August 2013
got the rs232 working via virtual panel.
just need to get it working on the Tx4 remote now

Jump to

Protected Feature Before you can reply to a message...
You must first register for a Remote Central user account - it's fast and free! Or, if you already have an account, please login now.

Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our Marketplace. For information on how to advertise your service or product click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.

Hosting Services by ipHouse