Post 1 made on Sunday December 3, 2017 at 22:27 |
newguy92 Lurking Member |
Joined: Posts: | November 2017 3 |
|
|
Does anyone know the proper driver or if there is even a driver for using ssh or telnet over RTI? I would like to be able to send commands to a switch for hdmi over IP routing using cisco switching. Not sure if this is possible but i have looked at using the HTTP authentication driver which i think is closer to what i need or i might just be implementing it incorrectly. Otherwise the 2 way string driver I figured might work well but again maybe implementing it wrong. would love some input if this has been done or if there is an easier way I have not tried. Thanks
This is what I am trying to send (all of the commands assuming the device has logged in already) obviously numbers are irrelevant
switchname: config switchname: interface fe 10 switchname: switchport general allowed vlan remove 2-9 switchname: switchport general allowed vlan add 3 untagged switchname: end
Thanks!
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.