Does anyone know the proper driver or if there is even a driver for using ssh or telnet over RTI? I would like to be able to send commands to a switch for hdmi over IP routing using cisco switching. Not sure if this is possible but i have looked at using the HTTP authentication driver which i think is closer to what i need or i might just be implementing it incorrectly. Otherwise the 2 way string driver I figured might work well but again maybe implementing it wrong. would love some input if this has been done or if there is an easier way I have not tried. Thanks

This is what I am trying to send (all of the commands assuming the device has logged in already) obviously numbers are irrelevant

switchname: config
switchname: interface fe 10
switchname: switchport general allowed vlan remove 2-9
switchname: switchport general allowed vlan add 3 untagged
switchname: end

Thanks!