Your Universal Remote Control Center
RemoteCentral.com
RTI Control Systems Forum - View Post
Previous section Next section Up level
Up level
The following page was printed from RemoteCentral.com:

Login:
Pass:
 
 

Topic:
ONSITE, NEED HELP! Hard-wired IR control of Sony AE1 OLED display
This thread has 1 response. Displaying all posts.
Post 1 made on Thursday September 14, 2017 at 14:30
Otter
Long Time Member
Joined:
Posts:
April 2006
30
My IR commands work if I set them to standalone, but I am unable to get them working via the hard-wired IR/RS232 port... I tried setting the frequency to 0 on a few buttons and that didn't work either...
Dan O
Post 2 made on Thursday September 14, 2017 at 22:38
Glackowitz
RC Moderator
Joined:
Posts:
May 2002
3,713
The ir input is a stereo jack. Use tip for signal and sleeve for ground. Ring in the middle isn't used.

There should be an ir port and a 232 port.
The letters T and G are very close to each other on a keyboard. This recently became all too apparent to me and consequently I will never be ending a work email with the phrase "Regards" again.

Jump to


Protected Feature Before you can reply to a message...
You must first register for a Remote Central user account - it's fast and free! Or, if you already have an account, please login now.

Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our Marketplace. For information on how to advertise your service or product click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.

Hosting Services by ipHouse