|Post 1 made on Thursday September 14, 2017 at 14:30|
My IR commands work if I set them to standalone, but I am unable to get them working via the hard-wired IR/RS232 port... I tried setting the frequency to 0 on a few buttons and that didn't work either...
|Post 2 made on Thursday September 14, 2017 at 22:38 |
The ir input is a stereo jack. Use tip for signal and sleeve for ground. Ring in the middle isn't used.
There should be an ir port and a 232 port.
The letters T and G are very close to each other on a keyboard. This recently became all too apparent to me and consequently I will never be ending a work email with the phrase "Regards" again.
Please read the following:
Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our Marketplace
. For information on how to advertise your service or product click here
. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.