Does anyone have experience using this driver. There is very little detail on the RTI Driver page for this particular driver. I have a Vantage Trainer setup with an XP-8S and a KX2 and a KX7. I have the VID Mapping down and have been able to trigger button presses as well as dimming sliders on the RTI. One thing i cant seem to figure out, is how to program a press and hold on the RTI to emulate the press and hold from a vantage dimming task/button. By mapping the VID for my dimming button to the RTI button, when i use it...all i get is a toggle, and no raise/lower on the press and hold.

I'm in the same boat. Any new info?

this project recently finished about a month ago. went off amazing. if you want i can send you my RTI file via email.
unfortunately you cant emulate any kind of press and hold functionality... but what i did do was create a task using variable tracking to emulate a "Stepped" dimming function. i can even send you the vantage file if you want to import the task programming, then you can just copy and paste... youll have to re-assign the load and LED assignment, but its relatively painless.

I would like to see the file if you are willing. The stepped interface seems cool!
I will send you my email in your inbox.

Check your PM.

in the programming section of Design Center, look for the prefix in the folders for H/M/L, those have the tasks for the stepped dimming. Since Integration Designer can't emulate the press and hold dimming function on the vantage side, i found this to be a viable alternative. Toggling the "Phantom Keypad" button map on the RTI side will just step the task on the vantage side thru each stepped dimming value you program into the task. My base Values are 100, 49, 9 and 0. each load or scene you want to do this with will need its own dedicated Numerical Variable to keep track of what state the load is in, make sure you keep the loads variable value "persistent" that way the vantage system will keep the load/Dim Value synced after a reboot, upload etc.
Hope this helps