Simple setup, simple question, but the diagrams are rather "varied", or whatever.
I have five keypads to control four zones, and want to know if the CB-8's 'output' connects to 'expansion' or 'RTI com' port on the XP-6. The latter is connected to the AD-4 from port1 to 'control' in via min-plug.
The basic commands were sent into the keypads and XP-6 without issue, show as 'updated'.
Years ago I did a fair bit of programming of T2 systems, but this is different and I don't want to mess anything up.
Once it selects source and vol works, then I can worry about some equipment macros.
Hardwired to LAN; router has found it, so that is OK
TIA,
Bruce
Last edited by BruceHinton on April 9, 2015 22:21.