Post 1 made on Wednesday December 31, 2014 at 00:07 |
tomciara Loyal Member |
Joined: Posts: | May 2002 7,965 |
|
|
i used the web interface to group zones 2&3 together.
I am using IR to control it - how do I turn those two on together, choose the source together, ramp volume simultaneously? If I use IR commands from one zone, only that zone responds.
Thanks in advance!
|
There is no truth anymore. Only assertions. The internet world has no interest in truth, only vindication for preconceived assumptions. |
|
Post 2 made on Wednesday December 31, 2014 at 18:29 |
ralliart329 Active Member |
Joined: Posts: | October 2007 655 |
|
|
I'm pretty sure their is a description of this in the manual. However I have never IR controlled one so don't know how this works via IR. I've always done it using IP and rs232 with the two way drivers
|
|
OP | Post 3 made on Friday January 9, 2015 at 00:01 |
tomciara Loyal Member |
Joined: Posts: | May 2002 7,965 |
|
|
Tech support - no can do.
IR is the ugly sister. Too bad.
|
There is no truth anymore. Only assertions. The internet world has no interest in truth, only vindication for preconceived assumptions. |
|
Post 4 made on Sunday January 11, 2015 at 11:24 |
ralliart329 Active Member |
Joined: Posts: | October 2007 655 |
|
|
May I ask why your limited to IR control on this project? With any processor you can at least do 1way rs232 and any xp processor both Ip and two way rs232 are easy to implement
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.