| Post 1 made on Thursday January 23, 2014 at 22:04 |
Wildracing22 Lurking Member |
Joined:
Posts: | January 2014
2 |
|
|
Hello,
I am a entry level programmer (sales guy today,lol) with previous experience in programming years ago when i installed systems.
Anyhow, i am experiencing a issue that i can not seem to figure out. I have my AVR connected via Rs-232, when i send a power off command the unit powers back on after a few seconds. I do not have a second code being sent, if i manually turn the AVR off via the front panel power button it will power back on a few seconds later!
Anyone have an idea of why? Its only when the serial cable is connected, it only does it when the processor is connected. If i reboot the processor then immediately power the avr off it stays off until the processor comes back online.
|
|
| Post 2 made on Friday January 24, 2014 at 15:17 |
ralliart329 Active Member |
Joined:
Posts: | October 2007
655 |
|
|
That's a new one in my book. Are you using one way serial commands or a two way driver? If you are using a two way driver I would call RTi to see if this model is compatible with their driver. If it's one way commands I'd suggest trying IR.
Maybe someone who's used this model before can be more help but I've never seen anything like that in all the RTI I've done in the last 8 years.
|
|
| Post 3 made on Monday January 27, 2014 at 23:13 |
ErikS Active Member |
Joined:
Posts: | July 2003
699 |
|
|
I assume you are using the driver. The older pioneer units(first 2-3 generations that had network and older) will turn on with any communication sent to them if they are powered off. The driver is constantly polling the unit based on how the newer units respond(it just returns whether its on or off instead of turning on). Even though they all use the same protocol or 99% of it the older ones responded differently for energy star ratings. I thought I read that the RTI developer that wrote that driver had a work around in the form of an unofficial driver but I have not used it. Try searching on RTI's forums.
|
|
| Post 4 made on Tuesday January 28, 2014 at 21:51 |
kgossen Super Member |
Joined:
Posts: | March 2008
3,026 |
|
|
^^^^^^ nailed it.
I have VSX-94 that turns on whenever I upload a change to the system. Luckily with Crestron I'm able to program a work around. If the RTI driver is constantly polling the receiver, this will always happen.
|
"Quality isn't expensive, it's Priceless!" |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
