Your Universal Remote Control Center
RemoteCentral.com
RTI Control Systems Forum - View Post
Previous section Next section Up level
Up level
The following page was printed from RemoteCentral.com:

Login:
Pass:
 
 

Topic:
IP control 2 Sharp displays independently?
This thread has 3 replies. Displaying all posts.
Post 1 made on Monday December 9, 2013 at 19:15
pgaiduk
Long Time Member
Joined:
Posts:
May 2011
22
Does anyone have an idea how one could IP control two devices from the same manufacturer independently which both use the same driver on the same network using one processor (XP-6)?
I'm pretty sure everyone will say no way - just use RS-232. but I just thought it might be a brain teaser.
Post 2 made on Monday December 9, 2013 at 20:59
jcbremotes
Long Time Member
Joined:
Posts:
October 2006
412
IP control is specific to an IP address, which is unique when done properly.
Post 3 made on Monday December 9, 2013 at 21:14
ralliart329
Active Member
Joined:
Posts:
October 2007
655
You have to set each TV to a different IP address. Then add the driver to your processor twice. Setup the two drivers to point to the two different IPs of the TVs.
OP | Post 4 made on Monday December 9, 2013 at 22:19
pgaiduk
Long Time Member
Joined:
Posts:
May 2011
22
DUH!
Thanks. I didn't think to add the driver twice.


Jump to


Protected Feature Before you can reply to a message...
You must first register for a Remote Central user account - it's fast and free! Or, if you already have an account, please login now.

Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our Marketplace. For information on how to advertise your service or product click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.

Hosting Services by ipHouse