Post 1 made on Monday December 9, 2013 at 10:39 |
yin Long Time Member |
Joined: Posts: | December 2008 49 |
|
|
is it possisible to issue a command that presses and holds the subtitle button (on Ipad)for 5 seconds,were I then can use the up and down arrow key to adjust the position of the subtitles-using RS-232 codes I thried #SSH+5\r and #SUH\r I hope someone can tell me how to make this command work Thanks
|
|
Post 2 made on Monday December 9, 2013 at 21:12 |
ralliart329 Active Member |
Joined: Posts: | October 2007 655 |
|
|
When you add the command onto a button you can check the sustain box in button properties and set the delay between repeats in milliseconds. This allows you to press and hold for 5 seconds.
If you haven't tried it yet the company my device has a two way driver for this player available on their website or the Rti dealer forum.
|
|
OP | Post 3 made on Tuesday December 10, 2013 at 07:09 |
yin Long Time Member |
Joined: Posts: | December 2008 49 |
|
|
Thanks ralliart329 the problem that I had seems to be a issue with the Bluray Avatar their I cannot use the #SUH\r I can only get it to work if I go over Setup, cursor down, cursor right and so on. With Apocalypto the #SUH\r and then Cursor 5 times up or down and then "enter" that worked by this way did not go with Avatar 2D I did not get it to run #SUH\r then #SSH +5 or -5 it does not jump from 0 to -5 or from -5 to 0 which would be the best and fastest way to programm the macro for 16:9 or 2:35 Subtitle shift
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.