Hey all. I have a device, the crap Fibe box in my earlier post, and I have found a new set of codes to try. I added them as a new device. Do I need to change all of the commands on every button on every page or is there a way top automatically replace all of the codes with the new set?

Thanks, Craig

There is a training video on the dealer site.

Once you add the new device it should have added a new page. Delete the old page and edit the activity macro to page flip to new page.

I'll watch the video, thanks.

I have a lot of custom pages so if I delete them I will have to rebuild them. In this case I just put the codes in one by one, but tech support offered another solution. When you delete the old device make a note of it's exact title. Save the new device as the same title and the codes will auto populate.

I was so far into this remote I didn't want to try something new but I'll give it a go as a test. It seems to make sense.

Craig

I would make a new file or remote, with only the cable box you are having trouble with. Load and test until you have working codes. Then change your file with the codes you know work.