| Post 1 made on Monday March 8, 2010 at 15:05 |
AZ_Pro_Installer Long Time Member |
Joined:
Posts: | October 2008
212 |
|
|
Ok, so does any one know if there is a way to utilize the RJ45 RS232 ports on a ZRP6 for a one way communication RS232? I know this can be done on the XP8, but I cannot seem to find port assignments in ID to do this. Is this not possible?
|
|
| Post 2 made on Monday March 8, 2010 at 17:41 |
jimstolz76 Loyal Member |
Joined:
Posts: | December 2007
5,607 |
|
|
You just use it! LOL I'm controlling my Panny plasma one-way with one of the RJ45 ports right now.
In your RS232 command, just select "[RS-232] Port 1" instead of "[CM-232] Port 1". You can't rename the RS232 ports unless you're using a 2-way driver.
Works just fine.
|
|
|
| OP | Post 3 made on Monday March 8, 2010 at 18:22 |
AZ_Pro_Installer Long Time Member |
Joined:
Posts: | October 2008
212 |
|
|
SNAP CRACKLE POP! Thank you Jim I didn't even think of checking on that!
Thank you very much!
|
|
| Post 4 made on Monday March 8, 2010 at 23:53 |
Glackowitz RC Moderator |
Joined:
Posts: | May 2002
3,793 |
|
|
Ditto on Jims post, I am using port 1 for a niles system and port 2 for a TV
|
There's no worse feeling than that millisecond you're sure you are going to die after leaning your chair back a little too far. |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
