Post 1 made on Tuesday December 22, 2009 at 12:25 |
AZ1 Long Time Member |
Joined: Posts: | February 2008 73 |
|
|
how do i write these rs-232 commands? i cant get this tv to respond at all. help please this tv was hooked up using amx and it worked over rs-232. do i have to change something ? wiring? crossover cable from tv to xp8?
|
|
Post 2 made on Tuesday December 22, 2009 at 14:50 |
Oz AVI Senior Member |
Joined: Posts: | November 2004 1,151 |
|
|
Yes, you do need a crossover cable.
|
|
OP | Post 3 made on Tuesday December 22, 2009 at 15:07 |
AZ1 Long Time Member |
Joined: Posts: | February 2008 73 |
|
|
i switched the pins 2 and 3 on the rj-45 side going into the xp8 and still cannot get anything to respond, i checked the baud rate and parity and start and stop bits everything looks good but this is frustrating, my code is ka 1 0\r for off and ka 1 1\r for on
|
|
Post 4 made on Tuesday December 22, 2009 at 19:04 |
Oz AVI Senior Member |
Joined: Posts: | November 2004 1,151 |
|
|
Can't go too wrong with the codes, other than that, when trouble shooting I wouldn't swap pins or anything at this stage. use a patch cable and a null modem cable to be sure, when that works, go from there.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.