Post 1 made on Monday November 16, 2009 at 13:50 |
gx270 Long Time Member |
Joined: Posts: | September 2005 194 |
|
|
So, I'm using an RTI T2CS, RP6, and Shinybow SB5644. I used the rs-232 commands from the library and plugged the cm-232 module into port 1 of the rp6.
It tested fine, but now that I have it installed at the clients house, it won't take an rs-232 commands.
I can change outputs via the front panel or ir but not rs-232.
Any thoughts?
Thanks.
|
|
Post 2 made on Monday November 16, 2009 at 15:28 |
TOOOLDAND TOOGRUMPY Long Time Member |
Joined: Posts: | October 2007 351 |
|
|
push the 4 pole plug into the rp-6 fully. caught me a couple of times.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.