Hey guys,

I really like the "please wait" animations from Joey, but seem to be having trouble dropping them on a T2cs.  I use the 240x320 with no trouble on a t2c, but it will not work on a t2cs.  As far as the specs go, they should have the same resulution???  How are you guys doing it?

Thanks in advance.

Internetraver,

I assign each animation frame as a background image under "page properties", then assign the animation through the macro editor.

This should work fine with all the 240x320 graphics.

I could send you a sample if you want in ID format...

Also, on a side note, rename each animation page to nothing, so when the animation runs, you dont see the page number up top.

Joey

Yup, I used the Loading bar on a T2Cs just today (thanks again joey)

However, I didn't do the full animation, this was a small system so I just switched to this page then switched back when the macro is done. This is just a T2Cs and RP1. Good call on not have a name for the page, that would look much better =)

Thank for the reply's guys,

I know how to run the graphic. My problem is that I can't drop the graphic on a t2cs.  If I have a test file with a t2c and a t2cs, I can drag the graphic on to the t2c with no problems, but I can't drop the graphics on to a t2cs for whatever reason.  Any thoughts on that?

Edit, Thansk Joey, That worked,

I should actually read your post before I reply.........


Why can't I just drag and drop the graphic like any other remote?

Well, you can, sort of...

Since the T2C-s is grid based, you cannot have any image dropped onto the page that is bigger than the grid.

You can however drop a background on any page, just hold down ALT while you drag it over, that tells ID that you want to copy that as a background!

Hope that helps.

Joey

holy crap, hold down alt and it just works!!!

i have been at this for a while and didnt know that, i think i love you man, lol!!

thanks for the shortcut.


steven

Very nice.  Thanks for the help Joey

im new to rti,
how do i work with a loading transition ?

on nevo i would just add it in to a macro,
having it jump in between pages . .

The transitions are page jumps.

You can assign page jumps in a macro when the button is assigned to "standalone".

In this "standalone" mode, all the codes & macros run on the remote, but you can also trigger macros that are stored on the processors.

thanks joey!