Post 1 made on Tuesday May 22, 2001 at 17:18 |
Some buttons on the remote need to be held down a bit longer to send the signal to the equipment and they work fine. However, when I use this same command in a Macro, it doesn't work consistently. Is there a way to have that command in the macro be "held down longer" as if you were keeping the remote control button pressed longer?
Thanks.......Joe.
|
|
OP | Post 2 made on Tuesday May 22, 2001 at 23:47 |
Daniel Tonks Historic Forum Post |
|
|
Check out the "repeats" option.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.