| Post 1 made on Wednesday May 28, 2008 at 16:01 |
Jimmy Bellagio Advanced Member |
Joined:
Posts: | January 2008
854 |
|
|
Pretty dumb queston, but how do you guys wire the high out on the RP-6 ? I never had a need to use it until now.. Do you wire the High out on the RP6 to the signal on the ECB5 and the ground to ground? How do you get the block power? I just want to see what people are typically doing in this installation and if they are plugging the power into the block or the RP6, etc. and want to make sure I am wiring properly.
Thanks
|
James S. Bellagio |
|
| Post 2 made on Wednesday May 28, 2008 at 16:11 |
SAAudio Advanced Member |
Joined:
Posts: | March 2007
993 |
|
|
Power the rp6 with power supply. There have been several who have damaged connecting blocks by powering them directly.
Then connect power and ground from RP6 to ECB5. Then run High Out to Signal In on ECB5.
|
|
| Post 3 made on Wednesday May 28, 2008 at 16:27 |
ErikS Active Member |
Joined:
Posts: | July 2003
699 |
|
|
As a side note, the connecting block doesn't have to have 12V+. Connecting blocks only need power if they have a powered device connected to them such as an ir receiver or if they are an amplified block such as a xantech 791-44.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
