| Post 1 made on Friday May 23, 2008 at 10:16 |
jimstolz76 Loyal Member |
Joined:
Posts: | December 2007
5,607 |
|
|
Just got my hands on a T1, finally.
When you hit Power Off (as in a global power off command) the source button that you were using stays lit. Is there a way to stop this from happening? It's like it needs a page flip to a Power Off page or something, but I don't see how you can do that with this remote. I'm probably missing something simple...
Thanks
|
|
|
| Post 2 made on Friday May 23, 2008 at 11:36 |
Glackowitz RC Moderator |
Joined:
Posts: | May 2002
3,793 |
|
|
Thats the way it is, there are only 8 pages(source buttons) so there is no where for it to flip to, the remote will time out after the set time and no butytons will be lit, They will have to press the lit source button again to reselect that source
|
There's no worse feeling than that millisecond you're sure you are going to die after leaning your chair back a little too far. |
|
| OP | Post 3 made on Friday May 23, 2008 at 11:39 |
jimstolz76 Loyal Member |
Joined:
Posts: | December 2007
5,607 |
|
|
OK thanks. I would have driven myself crazy trying to make it work...
|
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
