Post 1 made on Wednesday May 14, 2008 at 16:20 |
AndyM Founding Member |
Joined: Posts: | March 2002 1,470 |
|
|
Anyone have a set of working rs232 codes for the SP50 (Other SP models use the same)? I'm having a heck of a time finding something that works. If you have them in an RTI library that would be most helpful.
YES! I've looked at the manual and I've tried a bunch of different configurations of what they have. Tech support was helpful, but wasn't that familiar with RTI so he could only do so much. Tomorrow I'm going to make sure my equipment (CM232) is working properly.
Setup: T2+/RP6/CM232
Soapbox on: WHY THE F*%K DOESN'T RUNCO USE THE SAME PROTOCOL ON ALL THEIR PRODUCTS? THEY HOTROD SOMEONE ELSES PRODUCT WITH THEIR OWN GUTS ANYWAY!!!!!!!!!!!
|
|
Post 2 made on Thursday May 15, 2008 at 10:06 |
Greg C Super Member |
Joined: Posts: | October 2002 2,589 |
|
|
Can you get it to respond when you use Hyperterminal on your laptop?
|
CEDIA University Designer CAT Team Member CEDIA University Instructor CEDIA Registered Outreach Instructor |
|
OP | Post 3 made on Thursday May 15, 2008 at 12:56 |
AndyM Founding Member |
Joined: Posts: | March 2002 1,470 |
|
|
I got it to work...
It doesn't matter what the baud rate is set at on the plasma. You have to use 115300 (or whatever the highest one is).
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.