Post 1 made on Thursday May 1, 2008 at 15:00 |
RTI4CustomHomes Long Time Member |
Joined: Posts: | February 2007 41 |
|
|
Hello,
I was wonder what would be the best way to take an already programed T3 and put the same design and programing on an RK3? Is it even possible?
thanks to all in advance.
|
|
Post 2 made on Thursday May 1, 2008 at 15:11 |
Designermike Long Time Member |
|
|
Make a copy of the already designed T3, re-name the duplicate T3 file, choose device select Convert to RK3.
|
Crestron DMC-D |
|
Post 3 made on Thursday May 1, 2008 at 15:15 |
Glackowitz RC Moderator |
Joined: Posts: | May 2002 3,793 |
|
|
Thats an easy one, open ID then duplicate the T3 and it will ask for a new name, give the same name and add a 2 behind or whatever the new name will be
open the new duplicate you made, then in the headr at the top of ID Left click "Device" tab and scroll down to "Convert To" and it should pop up T2-C and RK-3 box
Click the RK-3 and it will tell you that once you click ok the T3 will become a RK-3 and cant be changed back (thats why create the duplicate to convert)
Now check all of your settings as some may not have converted...
Thats it your done...Upload and retest
Hope that helps you out
|
There's no worse feeling than that millisecond you're sure you are going to die after leaning your chair back a little too far. |
|
OP | Post 4 made on Thursday May 1, 2008 at 17:18 |
RTI4CustomHomes Long Time Member |
Joined: Posts: | February 2007 41 |
|
|
Thanks guys! That was too easy.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.