Post 1 made on Tuesday February 20, 2001 at 13:32 |
Scmucker Historic Forum Post |
|
|
Hi,
I have a list of RC5 discrete codes for my Classe SSP-75 processor. How can I program the T2 to use these codes directly. I tried the pronto edit route where I entered the RC5 codes into pronto edit and did a cut and paste of the resulting hex codes into the designer software using F12. Unfortunately the designer software says the codes are invalid.
Thanks for any help
scmucker
|
|
OP | Post 2 made on Tuesday February 20, 2001 at 22:01 |
Daniel Tonks Historic Forum Post |
|
|
You can't. The problem is the Pronto treats RC5/6 codes as special -- the hex is actually only a pointer for the remote to properly format it; you can't convert that hex to the RTI format. The only way would be to get someone with a Pronto to capture a "dirty" code from another remote.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.