| Post 1 made on Wednesday February 14, 2001 at 22:49 |
Shawn Worst Historic Forum Post |
|
|
I was getting very frustrated trying to find out why the hell my IR-543 wouldn't work with my RF-6 or my T2 in IR mode. Well, after many a trial and error, I tried messing with the level control on the back of the RF-6, and found that if I turned it all the way down, the IR-543 started to blink to signal it was receiving a signal. I then left the level all the way down, and put the emitter about an inch to the right of the IR receiver on the IR-543, and it's worked flawlessly ever since. I guess the IR receiver on the IR-543 is just a bit too sensative for most emitters.
I hope this helps out those with IR-543/RF-6 woes!
|
|
| OP | Post 2 made on Thursday February 15, 2001 at 20:03 |
Daniel Tonks Historic Forum Post |
|
|
I'll confirm that the IR-543's receiver is VERY sensitive and is easy to overwhelm.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
