| Post 1 made on Saturday March 15, 2008 at 16:59 |
thebland Long Time Member |
Joined:
Posts: | June 2006
200 |
|
|
I am preogramming a couple of these remotes for the 1st time.
Initially I entered commands so that all were fired out as IR commands.
Now, I have added an RF (RP6) and want to change all commands to RF mode.
HOw do I do this without having to do each button seperately? With the T3, I can 'Select All' and 'Copy' this..
I tried clicking on T1 device properties and changing it to RF trigger codes, but it is not changing the buttons...
How do I change all commands to RF without doing it button by button?
Thanks!
|
Jeff |
|
| Post 2 made on Saturday March 15, 2008 at 17:05 |
Springs Super Member |
Joined:
Posts: | May 2002
3,238 |
|
|
As soon as you add a processor... by default any single command will be moved to the processor.
As for macros... well those you can cut and paste.
|
|
| OP | Post 3 made on Saturday March 15, 2008 at 17:31 |
thebland Long Time Member |
Joined:
Posts: | June 2006
200 |
|
|
How does the T1 know I have added an RP6? Or does it always shoot out RF and IR?
Thanks!
|
Jeff |
|
| Post 4 made on Saturday March 15, 2008 at 17:35 |
rlustig Advanced Member |
Joined:
Posts: | June 2004
915 |
|
|
Once you add the processor in ID or TTD, the T1 will require a download. This changes it to send trigger codes.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
