Joe,
They’re a couple of ways to do this, the first is:
1. Create a button on the DVD page, using the button drawing menu on tool pallet.
2. Click on “assign pages” button on tool pallet (oval with green square) lower middle of tool pallet.
3. Click on button you created above and scroll down the pop up menu to the page you would like this button to jump to and click on it. That’s it! Now go to preview mode on top navigation bar (next to question mark) and try it out.
The second is to attach the page link to a macro:
1. Click on the macro button, this is again on the tool pallet upper corner second from right.
2. Click on a button to which you would like a macro, say watch dvd.
3. In the macro editor command section that pops up, write a macro that you would like executed, something like turn on dvd, wait 10 seconds, send play.
4. At the end of this macro chose page link and scroll down to the page of your choice and click it. From then on when that macro is executed the last command is a jump to the page of your choice.
Hope this helps.
Bill
www.homeautomationnet.com