Hey Everyone- I am a RTI newbie and I have an older T2. I have programmed similar remotes in the past and I have the remote, cable and software for the T2. I went through all the steps to "teach" commands from my donor remotes to the T2 and loaded them all into my IR Library. I know the T2 can be tricky to teach codes but after finding the proper alignment it captured all the codes with ease. Problem is, after trying to test the T2 to see if it worked I could not get the devices to respond to the T2 from the test screen in IR Capture. Thinking maybe it was the test feature I built a quick command program in TheaterTouch and downloaded it to the remote, still no devices would respond.
All command buttons and the remote itself are set to IR. Is it possible, or likely, that my remote is not putting out any IR signal? Any other ideas?
if you have a home movie camera, point it at the remote while camera is on and if remote is outputing IR you will see the front of the remote light up in the viewfinderr
If you are not seeing IR then yes there is no IR being sent. I would double check your programing and if you are sure that you programed it right then yes it is time for a new remote..I have not programed the older remotes but when you do not have a rp6 or rp1 in your project all codes are ir. If you do then make sure that the codes your are sending are programed in standalone
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our Marketplace. For information on how to advertise your service or product click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
