Post 1 made on Saturday January 19, 2008 at 20:27 |
Vanderson Lurking Member |
Joined: Posts: | November 2006 3 |
|
|
Hey gang! I just got my new T3 and RP6 from RTI. I have it controlling my surround sound system and multi room audio system (being run off zone 2 of my surround receiver). I have moved my old T2+ and RP1 to my bedroom and would love to use the T2+ to control the local system asl well as zone 2 of the surround sound receiver.
To sum this up, I'm wanna know if I can control 2 RF Systems with 1 remote control.
Is this possible? If so, what do I do and how do I do it?
|
|
Post 2 made on Saturday January 19, 2008 at 20:36 |
roddymcg Loyal Member |
Joined: Posts: | September 2003 6,796 |
|
|
Put the button/buttons in stand alone, then direct the function to where you need them to go...
|
When good enough is not good enough. |
|
Post 3 made on Saturday January 19, 2008 at 20:41 |
tgrugett Select Member |
Joined: Posts: | August 2004 1,850 |
|
|
The only thing to watch out for is the annoying fact that an RF trigger code will occupy the reception on both processors even if the trigger code is recognized by one.
I have done three RP1 units with one remote without issue.
|
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.